F Datasheet, F PDF, F Data sheet, F manual, F pdf, F, datenblatt, Electronics F, alldatasheet, free, datasheet. IRF Datasheet IRF Component IRF Integrated Circuit IRF Schematic IRF Application Note IRF IRF74 IRF7 IRF IR I RF F . datasheet pdf data sheet FREE from Datasheet (data sheet) QTRPBF 13QTRPBF 3QTRPBF QTRPBF TRPBF RPBF PBF BF F

Author: Zolojar Viran
Country: Kazakhstan
Language: English (Spanish)
Genre: Sex
Published (Last): 13 November 2006
Pages: 434
PDF File Size: 16.85 Mb
ePub File Size: 18.76 Mb
ISBN: 679-6-88474-553-5
Downloads: 57527
Price: Free* [*Free Regsitration Required]
Uploader: Arashikasa

I wanna try and find g7413 volt mods for it. Well, nothing else to do but give her a try then. My pop has the camera so I can’t take any at least not tonight. If the resistance between 13 and GND is ohms, then a 1K VR is gonna lower resistance by a solid 60 ohms, which may be to much to start with since we are shooting in the dark right now.

That sounds a bit low for Vddr, thats probably vddq.

The card is a pro Datashheet just got back from rma and it doesn’t look anything like the one I had, layout wise at least. Keep a good eye on the voltage as you adjust the VR.


Do a resistance between 13 and GND and post what you find.

Data Sheet Catalog: Begin marking SMD with F

Just odd the 13 is tied directly to that cap. Pin 13 is the inverting input for output pin Give me a resistance reading for pin 4 and lets see if we can change the Vddr by modding this RT IC.

If possible, please check the voltage on 14 and post that. I’m almost sure that the 2. I dont recall what the baseline Vddr is for the cards. There is nothing else really.

The back of the card is almost blank except for one mosfet which reads “APME” There are also small 3 legged ic things that read “PH0o BCP68” On the front of the card there are more things that look like regs.

Once we figure out which output is supplying the Vddr and Vgpu, we can try modding the inverting inpout pin each output pin. The LM chip is prob controlling either Vgpu or Vddr. I’ll try and see if I can get some pics, but those are all the ic’s on the card so can anything be worked from that?

Then do the connectivity test between those points and pins t7413, 7, 8, and Oddly enough I found a connection between the ricktek chip and the f4713 measuring 2. Those are the outputs. I would start with a 5kk VR just to be safe.


Got some pics now. I feel for ya tho: Ok, pin 5 is the actual output datasueet the RT ICs. Sounds like the vdd voltage right there. Anyone make sense of that one? We need to make sure its Vddr and not Vddq. Those are all the ICs on the board. If you dont get an increase after turns, then I would stop and we need to take another look at it.

IRF7413 Datasheet PDF

Resistance between pin 1 and a ground is Odd pcb layout vmods. If Output Pin 1 is supplying Vddr, then we try modding to pin 2. BTW HF, this is a not a ti I found connectivity between pins 13 and a cap on the back of the card that reads 2. Well I looked over the datasheet and which pin do you think is likely to be eatasheet

Previous post: